Self – leveling

  • Significantly reduced patching time
  • Reducing machine down time
  • Less patching during production
  • Less “Angel hair”
  • To be used for a wide range of material
  • Well marked creasing lines
  • Can be used with all old cutting dies (to be preferred to self-leveling knifes which would have to be installed in all old dies to achieve this effect!)

COMAT creates high profitability and a significant return-on-investment. One time cost for an investment in a ready-to-use starter kit (3 pieces: compensating plate, set of matts and cutting plate) are neglectable in comparison with the enormous time saving and higher production capacity.

No matter which material to be cut and no matter which machine is in use. From solid board to B-flute: COMAT achieves best cutting results. Even laminated material is cut successfully.

You already run your diecutter with thin cutting plates? No problem as they still can be used. You don´t use them? Now is your chance for change. With the new three-piece set you will obtain a new compensating plate which is 1mm less in thickness and prepared for using thin plates.